Installation Help

Before installation can begin, the application area must be cleared of any debris. With the microfiber cloth included and soapy water clear off surface. 

Once the surface is cleaned, coat the area in a plentiful amount of application gel with spray bottle. Make sure to get the entire surfaced covered.

Peel off the adhesive layer and carefully apply the film on the layer of gel from previous step. Correctly position the film to cover full area.  

Now that the film is set to be applied. You can begin using the squeegee. Apply adequate force in the middle of film area and remove applicator gel with yellow squeegee. Regularly checking to remove all bubbles under the film.  

Now that the film is applied and adhere to the middle of the area, from the middle out remove all gel bubbles under the film. If bubbles appear carefully pull up the film and coat the lifted area with gel and repeat process until all areas of the film are properly applied. 

Clean the surface of the film and stay out of direct sunlight for the next 30 minutes to an hour, for proper adhesive effects to take place